The height of feeding line is the same as the height of mold line used by the press. In general, the height of the mold line changes after the mold is replaced on the press, so it is also necessary to readjust the height of the feeding line.
But usually there will be have some questions from customer for the height of the feeding line.
1 Does all punch feeders is available to adjust the height of the feeding line?
All punch feeders are available. The air feeder, high-speed roller feeder, NC servo feeder, high-speed servo feeder, and 3 in 1 feeder all have feed line adjustment functions, which are mainly used to adjust with different molds.
2 After different mold was replaced every time, must re-adjust the height of feeding line?
Yes, different molds have different mold line heights. If the height of the feed line is not re-adjusted after the mold is replaced, the feeding will be inaccurate during the stamping process, and the finished product may be scratched or defective, more serious can cause damage to the mold and punch feeder.
3 How to adjust the height of feeding line?
- Install the punching mold before adjusting;
- According to the height of the mold to adjust the height of feeding line (as shown in the figure);
- Then install the matching mounting plate.