Feed Height Optimization

To begin enhancing your NC servo feeder’s performance, start with adjusting the feed height. Follow these steps:

  1. Loosen the M14 screw that links the NC servo feeder to the fixed plate.
  2. Next, loosen the nut positioned at the bottom of the fixed plate to facilitate feed height adjustment.
  3. Rotating clockwise will elevate the feeder, while counterclockwise rotation will lower it.

Pressure Spring Fine-Tuning

A crucial aspect of NC servo feeder optimization involves fine-tuning the pressure spring. Follow these instructions for optimal results:

  1. Adjust the spring on the NC servo feeder until the material and rollers maintain traction without slipping.
  2. Be cautious: excessive pressure may lead to material deformation, while insufficient pressure can result in inaccurate feeding due to roller slippage.

Material Thickness Adjustment

Ensuring precise material thickness alignment is essential for optimal performance. Follow these steps:

  1. Loosen the tightening screw using a 4mm hex wrench in a counterclockwise direction.
  2. Rotate the material thickness handwheel until the gap between the upper roller and the material measures approximately 0.2-0.5mm when in a relaxed state.
  3. Tighten the screw securely to maintain the adjustment.

Air Pressure Calibration

Proper air pressure calibration is critical for consistent performance. Follow these steps for effective adjustment:

  1. Pull up the pressure adjustment knob and adjust until the pressure gauge reads 5, then push down the knob to lock it.
  2. Clockwise rotation increases pressure, while counterclockwise rotation decreases it.

Width Adjustment of Material Blocking Wheel

Optimizing the width of the material blocking wheel is crucial for smooth operation. Follow these guidelines:

  1. Adjust the width to be approximately 2mm wider than the material being processed.

Belt Installation and Elasticity Adjustment

Proper belt installation and adjustment are vital for seamless operation. Follow these steps:

  1. Ensure the belt is adjusted to the appropriate elasticity.
  2. Avoid over-tightening, as it may shorten the belt’s lifespan, while overly loose belts can result in inaccurate or impossible feeding.

Understanding the Feeding Start Signal

The feeding start signal’s adjustment is determined by the press’s cam and plays a vital role in the feeding process. Here’s what you need to know:

  1. The cam of the press dictates when feeding initiates during the press stroke.

Relaxation Time Adjustment

Proper feeder relaxation timing is crucial for accurate material alignment. Follow these steps for effective adjustment:

  1. Initiate relaxation when the positioning pin aligns with the material’s pinhole.
  2. Conclude relaxation just before the feeding cycle commences.

By meticulously following these adjustment procedures, you can optimize your NC servo feeder’s performance, ensuring precision and efficiency in your operations.

NC Servo Feeder
NC Servo Feeder