Regularly check the operation of the Decoiler Straightener Feeder:

1. Operation panel buttons, the contacts are conductive, whether there is oil adhesion.

2. Whether the external wiring of the feeder is deformed, damaged, leaked or short-circuited.

3. The nc servo system is often the accumulation of dust and the ambient temperature is too high.

4. Check each contact point, the control panel relay is good.

5. In the electrical control box of the Decoiler Straightener Feeder, the cooling fan is to prevent the motor from overheating, and the cooling fan filter is used to protect the fan from dust, but if the filter is blocked, its function will cause the cooling fan to fail, and the temperature of the control box will rise, resulting in The triode is damaged.

Regarding the replacement cycle of the electrical parts of the Decoiler Straightener Feeder:

①The electromagnetic contactor and relay of the Decoiler Straightener Feeder have an electrical life. In order to prevent failures from causing problems, please replace them every 5 years or so.

②The capacity of the Decoiler Straightener Feeder servo driver will decrease due to deterioration. To prevent secondary disasters caused by failure, please replace it every 5 years or so. In addition, never disassemble or repair the servo driver.

③The DC24V regulated power supply uses filter capacitors on the circuit, and its capacity will decrease with the increase of service life. In order to prevent failures from causing problems, please replace them every 5 years or so.

The above is the information about the maintenance work of the Decoiler Straightener Feeder organized by Henli. Doing the maintenance work of the Decoiler Straightener Feeder at regular and fixed points can reduce the failure of the Decoiler Straightener Feeder and ensure safe production.